Casting Shadows Deluxe Bundle Organizer remix

thingiverse

This is a remix of ArcticZebra's design mainly due to the shadow dragon acrylic not quite fitting in any on the slots. I've added a hex token slot snoodlife's wooden hex tokens that show the buffs from the tiles. I haven't printed out this version yet, though I have printed out a lot of prototypes. This version is set to include the new expansion coming out Molten Rock. I'll add pictures after I get it printed out, likely this weekend. It also includes all the Kick Starter units. I have it cut into 3 sections because it is what my printer can handle. With the three sections in place, to get access to all the pieces, you probably want to remove the middle section from the box. This will give you easier access to get all the cards out. Things that go in each section. Cards and Hex Tokens - fits cards with sleeves in the two card areas. next to the card area are three slots for the base game resource tokens. 5 gems, 5 orbs, 3 fragments/curses will fit into the slot. Then the snoodlife's hex tokens are the last pieces that fit on the section. Hex Land Tiles section - This section has a large hex area for all the hex land tiles. above the Hex Land Tiles, you should be able to put two player boards. Next to the hex land titles and under those two player boards is an area for the larger shadow form meeples. Next to them, is an area for the acrylic stand bases, in sets of 2. And then final next to that is an area for the small form meeples. Player Board, Acrylic stand area - This has an area for the majority of the player boards plus game instructions. next to it are two areas for the acrylic stand units, one for shadow form and one for normal form. to the side of those is an area for your 5 dice, and then two areas for 10 status tokens each. You can fill one with the stun/frozen status and the expansion adds in 10 status tokens for Fortify and Scorch. I've also started putting the playmat under the print outs, since we rarely use the mats. I may make a design without the playmats one day. Update: I've printed it out and added pictures. I'm not sure if I want to reprint it but there are a couple of changes I would make. I was planning to make the curse/shadow token fit 3 instead of 5. I guess I got into auto pilot mode at some point as I remixed it three times before this final version. Also, there looks like there can be 2mm more along the length of the design, there is room that the pieces can move around. This part I'm fine with because you kind of want to pull the middle piece out to get to all the cards easier. I like the original design better because it didn't require this, but with the limitation of the height of the print to accommodate all the playmats.