Case lock replacement part

prusaprinters

Fits really tightly.If printed again I would consider printing it on the side for better strenght and with holes for screws instead of the small pins. Perhaps the radius for acceptinng the bottom part of the lock could be bigger, but this seems to work okay (maby it will wear the case counterpart fast, though considering the state of the case that does not bother me.Printed as draft (0.3mm layer height) for speed with 40% infill (just wanted to be sure it won't snap in my fingers, guess it could be less) with supports (only for the pins) in PLA (just becaouse I was to lazy to change the filament from previous print).