Case for Weatherduino AQM II with holder for Dostmann Stevenson Screen

thingiverse

This is a housing for the Weatherduino Air quality monitor II https://wiki.weatherduino.com/air_quality_monitor_ii with a holder for the Dostmann Stevenson Screen. The case design is based on @ jarekh3 https://www.thingiverse.com/jarekh3/designs, but still not a remix. I printed the housing with ASA filament for outdoor use. I decided on ASA filament because it is UV resistant and should therefore be well suited for outdoor use. Since I have the AQM II with an OLED display and I don't want to forego visibility, I have provided a recess to protect the display into which a 3mm thick plexiglass was fitted. The case can be printed without support, but this means that the writing could be a bit unclean. The same applies to the cover plate. The antenna hood can be screwed into the housing with a thread. Before doing this, however, de-grade the thread, otherwise the housing may tear. I have not yet tested whether the connections between the antenna housing and the housing are watertight, as I will paint everything so that it should be sealed.