Case for W3KKC's RA-35 Radio Adapter Interface Board

prusaprinters

For someone putting up a low cost repeater, the cost of a USB Radio Interface for any type can be steep. That's one reason I was thrilled when I found W3KKC's RA-35 -- only problem was, it didn't come with a case. Well, that can be fixed =] Here are some things to know about this case: No hardware required -- put the RA-35 in and snap the lid shut There are holes in the lid placed above each of the three LEDs No supports are required I hope you find it useful =] Print Settings Rafts: No Supports: No Resolution: 0.2 Infill: 25% Notes: Make sure you turn the lid upside down so the flat (top) side is down else it won't likely work real well =] Category: Electronics