Case for the Pimoroni Pico RGB Keypad Base

thingiverse

Simple case for the Pimoroni Pico RGB Keypad Base. Prints in 3 parts without supports. The Keypad cover and top cover should be printed top down to avoid using supports. The bottom piece has a cut-out in the bottom to reduce filament used, improve print time, and prevent the unit from heating up too much (the bottom of the keypad can get warm when the LED's are set to max brightness). Keypad base slides into the bottom part, then the keypad cover slots over to prevent it from sliding. Top cover can be popped off to allow access to the Pico. May not fit every USB cable as it has a recess that it will need to fit in but does work with a fairly large blocky one. Parts have ~0.2mm tolerance built in but some slight clipping may be needed to get the parts to fit together.