Case for screwdriver set

thingiverse

This is a case for a screwdriver set A, B. It fits screwdrivers with a hexagonal handle that measures 13 mm in length from side to side and has an extension handle in the center that measures 26mm. If your screwdriver is bigger or smaller than these dimensions, please adjust with slicer settings. The maximum length of the driver is 136 mm. Please print the lower part first; you can check which screwdrivers fit this case by examining the lower part. I am waiting for your report. Supports are not required. Caution: Please file down the nails on the lower part to a height of at least 0.3mm, as this will ensure proper function. If you do not adjust the nails, the case may never come off again. Printing time is approximately 4 hours and 49 minutes for the upper part and 4 hours and 5 minutes for the lower part. The material used is ABS plastic, with the upper part weighing 53 grams and the lower part weighing 46 grams (calculated by Slic3r's values). Updated May 29, 2017: 1. V2 is updated: I have adjusted the height of the nails to 0.7mm and deleted a hole to make printing easier without supports. 2. A flat version has been added: This design uses less material and reduces printing time while maintaining the same functionality as V1 or V2. 3. The two designs above are not tested: I do not need multiple cases, so I am waiting for your report!