
Case for RG351P
thingiverse
For this you will need : - 18 neodymium magnets° and super glue (4mm in diameter , 1.5mm in thickness ) - 4mm foam ,very soft foam is best ( you can use thinner or thicker foam if you want (3,4,5,6mm) , just adjust the scale pourcentage as shown in the picture above) - a sharp scalpel and painter tape to cut the foam - a piece of filament for the hinge (you may need the sand the piece of filament to fit the hole) - glue or thin double sided tape (recommended) - you can use coins to make the rounded corner and the holes in the top foam Print info : - no support - horizontal expansion : -0.1mm - 0.2mm layer height (dont go higher or else the hinge wont work properly) - PLA , PETG pretty much any hard plastic would work , i recommend using an impact resistant filament magnet : search 4x1.5 magnet on AlieExpress foam : you can use Neoprene Fabric , eva foam is a bit too hard
With this file you will be able to print Case for RG351P with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Case for RG351P.