Case for RAMPS Full Graphic Smart LCD (OpenBuilds V-Slot Mounts)

thingiverse

This case is designed to house the RAMPS Full Graphic LCD Smart Controller with precision. I created this specifically for use with the Reach3D printer, but it could be mounted to any printer with a v-slot aluminum extrusion frame or as a standalone case with any other printer. There are multiple mounting options available with this case. First, there's the top mount. This is designed to be mounted at the top of a vertical 2040 extrusion. There are two mounts for the top mount option: "Top Mount - Center" and "Top Mount - Offset." The offset looks unorthodox, but it works perfectly. I needed this offset to accommodate other items I have mounted on the top of my Reach3D printer, such as the stock spool holder and some custom wire routing. Next is the side mount. This mount is designed to be attached to the corner of a vertical 2040 extrusion. Specifically on the Reach3D, this mount goes on the vertical 2040 just above the plate that holds the YZE stepper motors. The mount should not interfere with the extruder motors or the travel of the gantry arm. This mount will swivel at both ends, allowing for a variety of positions. Last is a standalone option. If you like the case but don't want to mount it to the frame, you can still use the same case with the "Free Stand." Simply insert the "Free Stand" into the slot on the back of the case and it will sit on a table. Almost all of the items can be printed without supports. The only item that will require supports is the "Swivel Clip - Frame." The case was designed to require as little hardware as possible. The top mount requires no additional hardware. The side mount will require 2 x M3 12mm screws and 2 x M3 nuts (these nuts will press fit into the provided "M3 T-Nut" and are used to mount the Side Mount in place). Super glue is needed if you wish to use the included "Reach3D Name Plate." Update 10/17/2017: I replaced the Top Mount - Center file with a new one that fits better. There's actually two versions of this part, an "A" and a "B." The "B" version adds some additional features. There's a small round hole for the stock "Reach3D" printer spool holder. There's a slot on the left side for velcro or tie wrap as strain relief for hot end wiring. On the right side is a mount point for a part cooling solution I'm working on. If you don't want these additional features, use the "A" version. Print Settings Printer: Reach3D Rafts: No Supports: No Resolution: .2mm Infill: 50% Notes: The majority of the print does not need supports, however the "Swivel Clip - Frame" will require support for printing.