
Case for NTC's CHIP with side
thingiverse
Customized version of http://www.thingiverse.com/thing:1050735 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=1050735 Instructions Using the following options: header_height is set to 52 units. A single top screw will be installed. The back beams are disabled for now. Side beams are enabled by default. No additional screw mounts will be attached. VESAs are not required at this time. One battery pack is included in the design. Both sides of the enclosure will feature the same design. The board length measures 42.25 units. The board width remains at a standard 10.75 units. The front side will be mounted on by default. A left header bar will be installed for easier access. The back brick is currently disabled in this version. No reset button will be included. Side bricks are also not needed right now. The header width remains fixed at 6 units. The number of times the wall is applied has been set to 150. Wall thickness will be 1.75 units as per standard. A bottom plate will be installed for extra protection. The board height is measured at 61 units. Eight beam heights are enabled in this design. Right screws will be used throughout the assembly. Low-profile designs will be implemented twice. Left screws will also be used in conjunction with right screws. Finally, a right header bar will be installed to complete the look.
With this file you will be able to print Case for NTC's CHIP with side with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Case for NTC's CHIP with side.