Case for NanoVNA-H and TinySA

thingiverse

A case to keep my NanoVNA-H and TinySA together inside my toolbox, along with (most) of the accessories that they came with. I've intentionally resisted the urge to make room for RF connector adapters. A proper set of these pretty much requires its own case. Bolt closure is less than ideal in placement, but I felt too lazy to design anything better. You're welcome. Hinges are sized for M3 hardware. I used 20 mm screws into nyloc nuts, with (probably unnecessary) nylon washers on either side. The guides in the left-hand compartment are sized to the bend radius of RG-174. There's a socket for an additional load calibration standard as mentioned in the NanoVNA calibration docs; mine did not come with one, but I left space for it anyway. OpenSCAD source included if you want to make some changes.