Case for MKS Gen. 1.4

thingiverse

I started with the VORON case, but it didn't quite meet my expectations, so I moved on to dazza26's version, which was a much better fit :)\r\n\r\nI completely reworked dazza26's design, actually creating 95% of it from scratch :)\r\n\r\nThe drill pattern for 50mm fans varies slightly depending on the manufacturer, so I omitted any pre-drilled holes - just drill as needed.\r\n\r\nYou can mount this case to a 30x30 extrusion profile however you like. You'll need two 50mm fans, which will sit directly above the stepper drivers. \r\n\r\nBegin by mounting the case to the profile, then feed the LCD cables through - now it's time to install the board.\r\n\r\nI used the MKS Gen 1.4 Board from RepRap Discount and Revoltec 50mm fans in my build. Be sure to compare your board design before printing this case.