Case for FrSky RX6R receiver

thingiverse

This is my hard case for the FrSky RX6R with v1 board. It replaces the flimsy card wrapper, offering much better protection. There is a hole for the bind button (note that there is no access to the S.Bus and SPort connector). The signal pin of CH1 is marked by a dot. **27 Jan 2019. This print is specifically designed for receivers with the servo pins and bind button on the same side of the main board, as some receivers have their servo pins soldered on the reverse side. Please see photos, and check your receiver before proceeding** Instructions: * Print the top and bottom parts * Remove the card wrapper from the receiver. Don't throw it away... * Cut a piece from the wrapper 21 x 18 mm - this forms the bed for the receiver board. * Lay the bed in the base. * Place the receiver board over the bed. * Secure the top half with adhesive tape. The antennae may be supported at the exit holes using silicone rubber or hot glue. See screenshot for Cura slicer settings. If you make it and like it, please leave a comment. **Change log** 22/12/18 Parts are re-oriented to lie on X-Y plane, and combined into one STL file. 24/12/18 Improved fit, channel numbers replaced with single dot near CH1 signal pin.