Case for Flipper Zero Wi-Fi Module v1

prusaprinters

<p>Simple protective case for the Flipper Zero Wi-Fi Module v1 development board.</p><p>Flipper Zero Wi-Fi Board Docs: <a href="https://docs.flipperzero.one/gpio-and-modules/wifi-debugger-module">https://docs.flipperzero.one/gpio-and-modules/wifi-debugger-module</a></p><p>Models Available:</p><ul><li>Full Case<ul><li>Requires 4x M3 screws/nuts for rigid assembly</li><li>Much more reliabiliy rigid than minimal case</li><li>Both ‘base’ and ‘lid’ are available with and without cutouts for debug headers</li></ul></li><li>Minimal Case<ul><li>Slightly thinner than full case (7mm vs 9mm)</li><li>No tools or hardware required for assembly</li><li>Relies on friction fit for rigidity, may not fit properly depending on your printer's tolerances</li><li>If future disassembly isn't an issue a few dabs of CA glue on the posts can make the minimal case just about as rigid as the full case.</li></ul></li></ul><h4>Printing Notes</h4><p>These were tested on a Prusa MINI+ FFF printer with Prusament PETG. The models were built with the intention of making FFF printing as easy as possible.</p><p>The “full" models include recesses for M3 screw heads and nuts, so it can be useful to enable support with a tighter pattern spacing (1.2mm) and interference pattern spacing (0.1mm) to keep things cleaner. After printing and before assembly it'll be important to carefully clean the recesses out to make sure that the hardware fits and can maintain a flush interface.</p><p>SLA printing hasn't been tested but should work fine as well. If you make a print with an SLA printer I'd appreciate it if you could post a make with some comments. :)</p>