Case for Digispark Attiny85

prusaprinters

This is a simple box for the Digispark AtTiny 85 device. Simple and easy. I have used the Attiny85 to create a small device that would prevent my computer from going into sleep mode when connected and running macros on remote computers. Just move the mouse a little every 20 seconds. In order to load the code, you need the arduino IDE and configure it as I show in the image. There is a remix from this design because this one doesn't work on some of my laptops (https://www.prusaprinters.org/es/prints/53317-case-for-attiny85-version-2). The code is: include <DigiMouse.h> define led 1 define move_interval 3 define loop_interval 20 // en segundos void setup() { DigiMouse.begin(); randomSeed(analogRead(1)); pinMode(led, OUTPUT); } void loop() { digitalWrite(led,HIGH); int distance = random(100, 800); int x = random(3) - 1; int y = random(3) - 1; for (int i = 0; i < distance; i++) { DigiMouse.move(x, y, 0); DigiMouse.delay(move_interval); } for (int t = 0; t < loop_interval; t++) { DigiMouse.delay(500); digitalWrite(led,LOW); DigiMouse.delay(500); } } I recommend the PETg filament because it is a bit flexible and will help to get the device into the box. See images for help Print Recommendation: PETG filament layer height 0.2 mm nozzle 0.6 or 0.4 mm 15% - 20% filling without supports Orient the X on the bed Print instructionsCategory: Computer Summary This is a simple box for the Digispark AtTiny 85 device. Simple and easy. I recommend the PETg filament because it is a bit flexible and will help to get the device into the box. See PDF for help Recommendation: PETG filament layer height 0.2 mm nozzle 0.6 or 0.4 mm 15% - 20% filling without supports Orient the X on the bed Print Settings Printer Brand: Prusa Printer: I3 MK3S</div>Rafts: No Supports: No</div>Resolution: 0.2 Infill: 20%</div> Filament: Prusament PETG Red Notes: Care must be taken when inserting the device to avoid damaging any chip or component. See PDF for help