Case for Arducam OV5647 with CS Mount Lens

thingiverse

*** UPDATE - New File Added - "C Mount Camera Case Front Revision A.stl" ***\r\n*** Identical to "C Mount Camera Case Front.stl" but with slightly larger screw holes to make it easier to cut-in the M3 threads, and a slightly larger lens mount through-hole to avoid damaging the ribbon cable when the front is snapped over the lens mount. ***\r\n\r\nThis case was designed specifically for the Arducam OV5647 camera module which comes equipped with a CS-Mount lens.\r\n\r\nTo assemble this case, supports are only needed for the screw head countersink holes, and no brim or skirt is necessary if your printer has good bed adhesion capabilities.\r\n\r\nFour M3x8 screws are required to put this case together, and I recommend that the screw bosses be acetone-hardened and then carefully cut threads with an edge-ground screw as these were made very tight in order to clamp the shells together securely.\r\n\r\nThis design does not include a mount for a camera arm since so many exist and it's a simple matter to mesh-mix the desired one to the camera shell, or cut one from an existing arm and bond it to the C-Mount shell.\r\n\r\nThe opening for the lens is tight by design, so be extremely cautious not to damage your ribbon cable when snapping the case around the lens base. The lens itself does not have to be removed to fit the case front, but the locking screws must be taken out and replaced afterward.