Case for 3.2 inch TFT display and ESP32 controller

thingiverse

Case for the ESP32 D1 mini and a TFT 3.2 inch (ILI9341). I designed this to connect a ham radio transceiver FT-817 or FT-818 to the display. The USB port of the ESP32 will later only be used for programming, while the cable on the back is connected to the transceiver. More information about the operation available on https://www.youtube.com/watch?v=2vLFegkDQvQ. I used eSUN PLA+, but others should work as well. The holder for the ESP32 might be a little bit critical, as the edges of the board that reach into the brackets are only small. Take care to use only small amount of solder and cut wires short. Otherwise it might be difficult to push the board into the holder. To keep the board in place even better, you can add some spacer between the back plate and the board, but in my case it was not required. I used an infill of 20%, but other values should work as well. I've also added the stepper files in case you want to make changes.