Carrera track safety zone / Sicherheitszone mit Bande 1:32

prusaprinters

<p>This is a complete set of safety zone parts with barrier, attachable to the Carrera tracks with these red connectors (check my other designs if you want to print some of these: <a href="https://www.prusaprinters.org/de/prints/50970-carrera-track-connector">https://www.prusaprinters.org/de/prints/50970-carrera-track-connector</a>).</p> <p>Features:</p> <p>Every part can be printed in one piece (include color/filament changes as you like) or print bottom, middle and top separately and glue it together afterwards<br/> Every part has the same spacing for the connectors as the original tracks, so just connect them with the red connectors to the tracks and/or next safety zone piece<br/> Bridging legs can be added to support safety barrier for track parts which do not lie on the ground.<br/> Safety barrier is far enough from the tracks to support proper drift action (yay!)<br/> No supports needed! The bridges of the bottom part are short enough to print in the air and bridge them.<br/> For every carrera track piece (as far as I've found out) there is a corresponding inner/outer safety barrier, including start/end pieces.<br/> To find out what you need check for specifications in the internet (or, e.g. <a href="http://www.slotcars4you.de/shop/images/products/ue_schienen.jpg">http://www.slotcars4you.de/shop/images/products/ue_schienen.jpg</a>)</p> <p>Some of the track turns were bigger than my print volume, so I divided the safety zone by half. So for some turns you have to print two pieces for one track piece.</p> <p>If something doesn't fit properly or you're missing something, please let me know! Since these are a lot of parts I may have missed something (for sure). Please let me know when something's missing.</p> <p>If you print it post a make!</p> <p>If you like it tip me!</p>