Carousel holder for universal baby cradle

cults3d

I created this for my babies a while back. This universal support allows for someone to connect any piece of plastic, PET, PPT or pex-al-pex tubing to it and install it as a support for toys and carousels above the baby's cradle. You can use between 13mm and 16mm tube diameter. The approximate length depends on the width of the cradle, but it usually stays between 100 and 150cm. This support must be printed in two copies (one for each end of the tube) and installed as shown in the attached images. A 3x40mm wooden screw passes through the side hole and screws into the main body of the bracket. Do not drive this screw through the wooden rail of the cradle, but keep it below. This screw has two purposes. One of them would be to tighten the bracket on the wooden rail and the other one would be to lock the plastic pipe inside the part. Depending on the type of plastic tube you use, glue can be utilized for securing the tube inside the 3D printed bracket.