Carla and LEO's Sheep

myminifactory

From the book LEO the Maker Prince:http://www.leothemakerprince.comhttp://www.amazon.com/LEO-Maker-Prince-Journeys-Printing/dp/1457183145LEO commanded, "Create a sheep", and Carla obliged. The next thing you noticed was his nozzles warming up and his spools spinning rapidly, and out emerged this stunning sheep on the printing tray. Instructions: Print the sheep WHITE file (sparse fill is perfectly fine). Print the sheep BLACK file. (The latest upright version prints well without any support.) Carefully remove all support material from each file and insert the black parts into the white part. You'll find a nose, ears, and four legs that need to be attached. Make sure the legs bend inwards towards the body's interior. A helpful tip from Jen Adams at MakerBot: place the legs most of the way in (remembering they should curve inward) and then gently press down on the body while it's resting on a table surface. This will get the legs to snap into place and fit snugly.