Card Holder

thingiverse

This Card holder was created with Tinkercad (https://www.tinkercad.com). Version 1.0. Print Settings: Printer Brand: RepRap Printer: Prusa i3 Hephestos Rafts: Yes Supports: No Infill: 10% Notes: You can print this piece with various different parameters. My suggestions are: Even if a 0.15mm thick layer is sufficient to print it, You should use 0.10mm instead. A 10% infill is enough to get a solid and yet resistant card holder, you can reduce it to 8% if you want but if you don't mind the printing time, 15% is much better.