Carburetor Workstand

thingiverse

It was time to rebuild the Carb in my project car and decided that it would be nice to have a level platform to work on it. You can rest the carb on its baseplate or flip the stand over and rest it on the air cleaner flange to gain access to the underside. I had seen products like this on Jegs and Summit and decided to make my own version. Intake manifold spacing is for a Holley 4150 carb but should work for most V8 intakes (5.125" x 5.625") and a air cleaner flange diameter of 5". Again, this should be pretty standard but you should double check before you print. Enjoy! Instructions Make sure to grab (4) 3 1/2" long, 1/4-20 bolts and nuts for the base plate. Feed the bolt up through each leg and tighten with a nut. You may need to add washers under the nut to give you clearance for your throttle linkages.