Carburetor Stand - Autolite 2100

thingiverse

This thing was made with Tinkercad. I used archistrong's original file as a starting point, and then added columns for a two-barrel so I could work on the autolite 2100. It should work with other two barrels too, but I haven't tested it. Print Settings Printer Brand: MakerBot Printer: MakerBot Replicator (5th Generation) Rafts: Yes Supports: No Resolution: High Infill: 10% Notes: Set for three shells with a layer height of 0.05 mm Post-Printing The middle supports may look higher, but they are in line. This is with the carb sitting on the posts, no bolts needed, just lined up with the holes. This is with it sitting upside down in the hole. How I Designed This Designing this thing. Essentially, I took Armstrong's original file for the Holley Carb, and then imported it into Tinkercad. I added two columns in the middle for the two-barrel carb, and then brought it into MakerBot. Once in MakerBot, I increased the shells to three, and set the layer height to 0.05 mm.