Carbon Tube FPV Racer (quadcopter)

thingiverse

This quadcopter design utilizes a 10mm diameter carbon boom/tube. Its size depends entirely on you, making it possible to fit props between 3" and 6". The canopy, if printed in TPU, can accommodate any FPV camera. The camera width that can be fit is approximately 20mm - 22mm. Revision 1: Print Settings section added. Additions made to shopping bag section Shopping Bag Mechanical Parts Bolts N' Nuts 4x M3 25mm for main plate 8x M3 20mm for motor mounts (2 for each motor mount) 8x M3 Anti-Vibration screws for pdb and flight controller - https://goo.gl/BRuA3P 16x M3 10mm for the motors 2x M3 8mm to attach the canopy on the stand offs. 12x M3 Locking hex nut - https://goo.gl/2HQyYc M3 Washers - https://goo.gl/9jAQnY (for every bolt that goes through the carbon tube) Other 2x Carbon Fiber Tube (outer diameter 10mm) - https://goo.gl/mo1M1y 1x Blue thread lock loctite 1x Silicon double sided tape for ESC's caps and attaching ESCs on the tubes. Tightening should not be too tight. Electronics 4x Racerstart TATTOO 35A - https://goo.gl/Spvbcy 4x RCX RS2206 2400kv - https://goo.gl/Pcp4Hq 1x FrSky R-XSR (Taranis compatible receiver) - https://goo.gl/vrJUBn Flight controller and VTX - Option one MATEK F405 - https://goo.gl/R51vYC MATEK FCHUB-VTX - https://goo.gl/ioDU4U Flight controller and VTX - Option two Holybro Kakute F4 - https://goo.gl/hGH4SU MATEK VTX - https://goo.gl/DwB35f Print Settings and Materials Main Plate Material: PETG or ABS or Polymax PLA, which is highly recommended. Fill Density: 50% for cubic or 35% for honeycomb. Perimeters: 5 Top and bottom layers: 4 Supports: Yes Motor Mounts Material: PETG or ABS or Polymax PLA, which is highly recommended. Fill Density: 50% for cubic or 35% for honeycomb. Perimeters: 5 Top and bottom layers: 4 Supports: No Canopy Material: Polymax PLA or TPU, which is highly recommended. Fill Density: 50% for cubic or 35% for honeycomb. Perimeters: 3 Top and bottom layers: 3 Supports: Yes Motor Protector Material: Polymax PLA or TPU, which is highly recommended as it will also work as a soft mount. Fill Density: 50% for cubic or 35% for honeycomb. Perimeters: 3 Top and bottom layers: 3 Supports: No ESC Cap Protector Material: PETG, ABS, PLA or TPU. Fill Density: 50% for cubic or 35% for honeycomb (does not really matter as it is aligned vertically) Perimeters: 3 Top and bottom layers: 3 Supports: No