Carbide3D Sweepy 2.0 Customizable Small Vacuum Adapter

thingiverse

Here's an OpenSCAD script to allow you to create a replacement small adapter for your Carbide 3D Sweepy 2.0 to support vacuum hoses up to approximately 50mm in diameter.  I'm including several pre-built stl's including a replacement of the original small adapter and tall and short versions for a Fein 35mm hose end -- or Fein's older hose design from the stone age (Fein's current hose end is 36mm). The script is set up to use the customizer and has plenty of "knobs" for you to hopefully dial in whatever you need. Print it in the created orientation. The only overhang is the outer flange, but the scad script gives you an option to taper the bottom on that flange (and set the angle of tape too) so that you can avoid supports (this is enabled by default with a 50 degree from horizontal slope) The example print in the picture is the "tall" 35mm Fein adapter, printed in PETG using a 0.4mm nozzle and 200u layer height. You can likely print with any of your favorite "coarse" settings as there's not a lot of detail in this type of model.