Caravan grey water waste pipe support

thingiverse

Following my research on caravan grey water waste (https://caravanchronicles.com/2013/05/26/connecting-your-drainage-on-serviced-pitches/), I purchased the necessary components and have been very pleased with using them. Nevertheless, I discovered that if unsupported, the piping tends to sag and subsequently the water does not drain properly. So I designed a small waste-pipe-support, drawing inspiration from the alphabet is not my strong suit, but it was a good starting point. From this single design, I printed approximately eight copies using the same model, but in Cura, I adjusted only the height of each one to range evenly from about 80mm high to 180mm high. They can be stacked for saving some space when packed up These completely solved the draining issue. I printed them in PETG for better weather and UV resistance.