Car Wiper Blade Rubber Cutter

cults3d

A model that can give a little bit of life on you car old windshield wipers. What you need: A Double Edge Razor the better the quality the better the cut. How To: Model Print the model but depending on the slicer program put a stop at layer in order to insert the razor with a little piece of tape as the picture shown.(instructions if you don't know here)https://www.youtube.com/watch?v=QuCIVJ14Zgw Car Wiper Remove the wiper from the car. Clean it and straighten it as possible. Don't use it on wiper with torn rubber as it will not work. Insert the first portion and after the initial cut grab and pull the wiper from the back side. The razor that is used at this design is very thin so use should pull at slow and steady pace.