Car Seat Tidy

thingiverse

This is my rendition of a car seat tidy. I printed it in PLA as an experiment, but I'm not convinced that it will withstand heat adequately for use inside a vehicle during summer months. The product consists of two distinct parts, which are then secured together with three 4 x 3/4" screws. The top section took approximately eight hours to print using a 0.4mm nozzle. In contrast, the base component required twenty hours to complete due to its honeycomb infill design, which is intended to enhance stability. To minimize printing time for the base, I suggest utilizing a 5% infill rate. I've also designed an alternative version of the holder with a shorter base that should fit as well.