Car Cup Holder

youmagine

I created this design in Blender without a specific car model in mind. However, it should easily fit into your vehicle or any other location you prefer. I've included the Blender file so you can modify the proportions and shape to suit your needs. You might want to add another clip or feature - feel free to do so! It took less than 30 minutes to design this item and under two hours to print. The bottom lashes only require the first layer, allowing you to cover them with tape to prevent material lifting. To print it, I applied spray glue to the heated-bed's tape first, then covered the lashes with additional tape after the initial layer. Next, I increased the printing speed to 300% in Repetierhost. For the first layer and startup, I used only 50% or up to 100%, depending on how well my calibration was done.