Car Amplifier Bracket

grabcad

This is my model of a project I did for my 1999 Isuzu Rodeo car stereo amplifiers. I mounted it on the back of the rear passenger's seat which folds down.Here is a list of parts I used in this project.3-Way 4 pin connector:https://www.amazon.com/gp/product/B01ACC13VA/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1Extension 4 Pin Cables:https://www.amazon.com/gp/product/B016KSONJ4/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1Led Ribbon:https://www.amazon.com/gp/product/B00B2F3KDQ/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1Power Supply: (You don't need this if you are planning to use it in your car, you can use your vehicles 12VDC power to provide power to the led ribbon(s) I had one laying around, so I used it for testing purposes as I built the light assemblies.https://www.amazon.com/gp/product/B01461MOGQ/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1I use this VHB tape to secure the LED ribbons as the tape on the back does not hold up to change in temperature. Where I live, the temperature inside the vehicle can be as high as 120°F to -50°F. This tape keeps the adhesion with expansion and contraction. I have been using this stuff for years.https://www.amazon.com/gp/product/B0016HGFXW/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1Aluminum Z-Barhttps://www.mcmaster.com/7062T13/Kenwood Subwoofer Amp:https://www.crutchfield.com/p_113X5021/Kenwood-Excelon-X502-1.htmlKenwood 4 Channel Amp:https://www.crutchfield.com/p_113X3024/Kenwood-Excelon-X302-4.html1/2 Plywood for amp main base, but if I were to do it again, I would use 3/4" plywood or composite material because the 1/2" plywood flexed a little.3/8" Aluminum for amp plates, they serve as a heat sink as well. I DA'd the aluminum surface to give it some shine. DA means you take a scotch brite pad and a random orbital sander and sand.Carpet is your choice, if you made the main base from something other than plywood it may not need carpet. maybe composite material, aluminum, or UHMW.