Capricorn Bowden Tube Cable Clip

thingiverse

This is a straightforward bowden tube/cable clip (with rounded corners) engineered specifically for the Capricorn Bowden PTFE Tubing used with 1.75mm filament. It has a snug fit on the tubing, which prevents it from sliding off easily. Three to four of these clips should suffice. I employed a layer height of 0.1 and 100% infill in this print, which resulted in a slightly stronger component. Due to its small size, some form of adhesion may be necessary to prevent it from lifting off the build surface. After carefully removing it from the build surface, I smoothed out the edges by rapidly rubbing them on an old piece of denim.