Cap/Lid Piece for The Handy

thingiverse

I like my handy to have two of the handles from ethanfel's original design but I find a cable tie does not cut it and the handy pushes its way "out of battery". I designed this tightly fitting lid piece to hold the handing into the second skin ethanfel designed so that it cannot move free. I have not tested this over a long time but it seems to go on and off and hold the handy in place I have not tested with any of ethanfel's other attatchements as i have only used the second skin and handles. TODO at some point: Reduce models volume (longer to print than I want). add hook/belt clip to lid to hold in place for hands free. add ethanfels mounting points to the sides of the cap. add Tactical rail for the lolz Printing: Printed in PLA or PLA+ (or similar) 20% infill (I used Triangle infill) Tree Supports (placement everywhere but touching buildplate should work. I also used a brim but I always print with a brim so I have a chance to correct level at the start of the print Orient the model so that the top/flat section is touching the buildplate. You will need some M3 screws I used a 10mm length thread (x2) you will also need Brass Knurled nuts (x2) just like the original model I used 6mm long ones but you could use anything smaller too it just needs to hold (advise using super glue or even a soldering iron to melt knurled nuts in place after fitting) I used a a m3 bolt and washer to simply pull the knurled nut through the hole into place.