Canadian FN C1 Sniper Scope Mount Set (Updated)

grabcad

3D scanned from the real steel/genuine surplus scope mount. Same with the plunger, rail cover and lever.UPDATES:1. I've re-uploaded all files since 2 of them (plunger and lever) needed to have important holes put in them (the holes were for the most part, covered) so you could assemble them without guessing where the holes should be and "Reproduction" has been added to those all parts in areas where you would not see it unless you are looking for the word. This is so no one tries to pass this as genuine, or rather make it harder to do so.2. The pin should be taped into the plunger instead of being screwed in like you do in the original real steel version. Keep in mind its not as secure as how it's suppose to be put in so you might have to be creative putting everything together (holding the parts together while screwing the rail on the mount.If you have any questions (like removing the word stamped on all of them depending why), feel free to message and ask.***NOTE: As the threads for the screws will likely not show where they are supposed to, it will be up to you to figure out how to put everything together (add threads yourself be means of tap and dye or threaded drill bits, etc.). You will also need to buy yourself a spring for the plunger.Additionally, some metal 3D printing shops will not print firearm parts so you will have the change the name of "Scope Mount" to something else and hope they aren't the wiser.To drill the holes wider or to use a tap & dye set on the holes to put screws in to put the mount on the adapter, you will need to submerge that part in vinegar or else the steel you print this out of will tighten (chemical reaction) and the vinegar prevents that from happening.***Youtube video on how to dissemble and reassemble the real one: https://www.youtube.com/watch?v=9ErPSaSt4zA