Can holder

thingiverse

Are you tired of soda cans tumbling around i your backpack? I was. This design is for 4 cans that fit in backpacks 25-30 cm wide (~10-12 inches). The holder is 28,5 cm (~11 inches) long (the two halves glued together), 7,36 cm wide (~3 inches) and 5 cm (~2 inches) tall. It will hold four regular cans ( 330 ml - 66 mm / 2,6 inches in diameter). I do believe it can hold the taller 500 ml cans with the same diameter, without risk of them slipping out (as long as you remove you backpack before any cartweels). It will sit at the bottom of the main room of a backpack and fix the cans in place, so they dont knock around each other and the other stuff in the backpack. The model is optimized for sturdyness with 1,6 mm walls, top and bottom. Print two and glue them together. I printed mine with supports under the three pegs in the square end, and support blocker in the three holes at the same end. Its is my first creation, so if you have any ideas for improvement, please let me know. Printed on Ender 3 v2.