CamGrip - Modular Phone Grip with Battery & Shutter

prusaprinters

A modular phone camera grip based on SnapGrip. Features a portable battery compartment and a mount for a bluetooth shutter remote. Compatible with MagSafe, PopSocket, QuadLock, and more. 💖 AttributionThis project uses modified versions of the following designs that are licensed under the CC BY 4.0 license.PopSocket Mount by @adammelanconQuadLock Mount by @vinzcenzo 🔩 ComponentsBaseBaseSupports recommended but not required.Phone MountsMagGrip can be mounted to your phone in several ways:MagSafe StickerRequires a MagSafe Magnet sticker.PopSocketPopSocket mount by @Adammelancon.Supports recommended.QuadLockQuadLock mount by @Vinzcenzo.Supports recommended.BlankUseful for remixing or DIYing.CapsThe CamGrip requires a total of 2 caps. One of which must be mirrored.Finger Grip Charge Hole Camera ShutterDesigned to fit a generic bluetooth camera shutter.Supports recommended.BlankUseful for remixing or DIYing.Other PartsYou'll also need some additional components:4 * M3 Screws/BoltsRequired.Can be 8mm-12mm in length.4 * M3 NutsRequired.Tube-Style Power BankOptional.I had a heap of these sitting around that I had received for free from various conferences.Bluetooth Camera ShutterOptional. Found on Amazon for cheap.Superglue  🪛 Assembly Instructions3D-Print Base component.3D-Print 2 Cap components.3D-Print a Mount component.Insert Power Bank into the Base component.Attach the 2 Caps to the Base component using 4 M3 Screws and 4 M3 Nuts.Attach the Mount to the Base component.If you're using the Camera Shutter component, slide it into the corresponding Cap.Attach your phone and you're done!