Camera stalk for Raspberry Pi Camera

pinshape

This is the camera stalk for the Raspberry Pi Camera. It elevates the camera to an optimal height, reversing its mount so that it can face the delta printer build plate directly. This is part two of a three-part series needed to mount your OctoPi to the side of your delta printer using 20/20 extrusion. Print Settings: Rafts: No Supports: No Resolution: Any Infill: 40% Notes: Print this at a slower pace and with a lower temperature, ensuring that the upright section has sufficient resolution. If not, you may lose detail on the smaller part, resulting in a rounded appearance.