CAMERA SLIDER with GoPro mount

thingiverse

Slider with a GoPro mount firmly attached using an Arduino script that's already been created. Designed for use with 8mm rails and igus linear bearings, you'll need: * One M5 nut to secure the GoPro mount. * Four M3 screws (15 mm long) and nuts to hold the carriage in place. * Two M3 screws (5 mm long) and nuts to fix the motor firmly. * A GT2-6mm 3D printer belt for smooth movement. * An Arduino nano microcontroller. * An ULN2003 chip to control the stepper motor accurately. * A linear potentiometer with a resistance of 1KOhm. * A power bank or an external power supply unit. * A mini USB female connector, where the power supply will be connected. From there, two wires split off: one connects to the Vin on the Arduino nano, and the other wire connects to "COM9" on the ULN2003 chip and the red lead of the stepper motor. This setup is necessary because the motor can easily overheat and damage your Arduino if it's driven too hard with a heavy load. Here are the parts you'll need to print: 1 x Gopro_Wagen1.stl 2 x deckel.stl 1 x soporte_nomotor_bonito.STL 1 x soporte_motor_bonito.STL 1 x tapa_soporte_motor_bonito.STL 1 x 28byj-48_gear.STL Check back soon for updates.