Camera Shelf Mount
thingiverse
Made in pieces to make printing easier. The top half CMA_06 can be tapped M4 and two M4 x 12mm bolts can be used to tighten it to a shelf. The lower slot should be wide enough to capture M4 nuts. After CMB_07 is bolted to the slot on CMA_06 the camera can be attached with a 1/4"-20 capture bolt. If the assembly is too floppy add Stiffener_02 before attaching stuff to stuff. When you're satisfied all is well attach it to a shelf and you're good to go. Oct 22: I notice that the weight of a camera makes the whole thing sag over time so I've added HorizStiffener_01. Bolt one end to bottom of CMB_07 then adjust the other bits to push on something under the shelf to increase stability. A good choice for bolting the stiffeners together is to use carriage bolts secured with wing nuts. But M4 carriage bolts are terribly expensive: $2.00 apiece on Amazon!! So I created a second set: HorizStiffener_02 has wider slots for #10-24 carriage bolts that are only $0.29 apiece from www.specialtytool.com.
With this file you will be able to print Camera Shelf Mount with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Camera Shelf Mount.