camera mount with tilt

thingiverse

I craft this custom mount specifically for my Nighthawk 250 quadcopter, but it will accommodate most other 250 quads with ease. Performance is exceptional, eliminating the hassle of staring straight down while flying! The pin hinge glides smoothly, and I'm thrilled that the entire piece prints in one shot. My camera, a compact 21 mm square with lens attached, requires a 17 mm diameter hole to pass through - conveniently situated 35 mm high above the quad's 42 mm-wide posts. To assemble, ensure the mount is correctly positioned on your printer, taking note of any orientation discrepancies possibly inherent in the STL file. For best results, print it with a raft and adequate support; solidify it after printing, then simply break off any excess supports by applying gentle pressure.