Camera Mount for TAZ 6 with Raspberry Pi Camera Module V2

thingiverse

I needed a camera mount for the TAZ 6 that attaches directly to the bed, so I created this design specifically for the Raspberry Pi Camera Module V2. This mount prints in two parts that snap securely under the bed, held in place by a cable tie at the same spot where you'd normally secure wires. It also features a channel for routing the ribbon cable from the RPi to the camera. Originally, I planned to add a cap, but it turns out the camera module stays firmly in place without one. The accompanying .gcode and S3D .factory files are available for download. If you require any further guidance on printing, please refer to these resources for detailed instructions.