Camera Mount for Logitech C920 Webcam

youmagine

The standard mount on the Logitech C920 is suitable for attaching at the top of your monitor or perhaps on a desk. However, it doesn't sit well on the corner of an Ultimaker and crucially doesn't allow you to angle the camera downwards enough to capture the tip of the extruder in the middle of the screen. These two parts screw together and secure with a small grub screw that holds the camera firmly in place. Additionally, screws attach it directly to the Ultimaker itself. You can adjust its angle from 0-60 degrees without worrying about it bumping into anything or falling off during a print. The hinge is formed by adjusting screws that allow you to fine-tune the tension on the hinge. This area may require further development as the screws tend to lose their tightness over time. (I was unable to successfully save my arrangements using the online assembly editor, so I took screenshots instead)