Camera Mount Fat Shark CMOS700

thingiverse

I am installing a flush fitting camera mount on the CMOS 700 V2 Camera as provided in many Fatshark kits. This base has no incline to it, being completely flat. So far, I have not tested the mount on a quadcopter, but it comes with a very robust protective case that should be invisible in footage. If visible, I'll modify it slightly. The dimensions of the camera mount are L x W x H: 35mm x 40.5mm x 25mm, which makes it sit snugly under 25mm decks. The total weight of the mount is six grams. A key note to remember is that this Case requires a fair amount of force to install and remove the camera. Printer settings: Printer: CTC Dual Rafts: Yes Supports: Yes Resolution: 0.2 mm Infill percentage: between ten percent and fifteen percent Notes: Using a fifteen percent infill makes it very strong but for weight considerations, lower infill percentages should be considered with ten percent likely being a better choice.