Camera Cold Shoe Cable Management (modified for Lumix G85+others)

thingiverse

This is a remix of Nate456789's 'Camera Cold Shoe Cable Management' print here: https://www.thingiverse.com/thing:2204124 This was modified to better fit my Panasonic Lumix DMC-G85. The original print assumes a cold/hot shoe that can 'pass through' while the Lumix is blocked by the camera body on one side. This also prevents use of the locking piece from the original print so it has been removed. There's enough friction in the fitment that it doesn't seem to be necessary to lock into place. The main modification was simply cutting down the one end that the locking piece clicked into and was no longer needed. I also opened up the cable holder a little bit to allow the micro-HDMI adapter cable I'm using with this to better fit. Internal diameter is the same, just the 'jaws' are opened slightly. I went overkill with the print with a 0.12mm resolution and 100% infill. The original print parameters should be fine and I imagine a basic 0.20mm/20-25% infill print may work fine as well. YMMV of course. While this is modified specifically for my DMC-G85, this likely fits other Panasonic cameras and even other brands since the hot/cold shoe mounts are standard.