Camera Arm - Standard Tripod Mount

thingiverse

Arm style camera mount I created for Octoprint and my Logitech c920 webcam. This design is made to fit onto 4040 or 2020 extrusion using two t-nuts. Tested and fitted on Ender 3. Default Setup uses five arms, but this can be extended or shortened as needed. All nuts and screws have an inset for easy installation and a clean look. I am happy to create additional mounting styles - just send me a request! Print Settings: - Supports are recommended everywhere, especially for 50 degree overhangs; increase support gap to make support removal easier. - Recommend print speed of 40mm - Infill density is best at 15% or greater - Keep temperature settings at the best setting for your brand's filament Hardware Needed For Default Setup: - Seven M5 hex nuts (M4 if you cannot get a tight tolerance/print above .1 layer height) - Seven M5 screws, 18-20mm length is recommended for a flush fit (M4 if tolerance is too tight) - Two 5mm t-nuts for mounting to 4040 or 2020 extrusion - Two 5mm, 14mm long for mounting base to extrusion - One M6 screw, 8mm long, for mounting camera on base with standard 1/4-20 tripod mount UPDATES: v1.2 - Added STEP file per request - Added 2020 base mount per request v1.1 - Added larger cable management clip; now accommodates 2-5 mm cable thickness - Added Gcode with all parts in correct print orientation, picture of print orientation added