CamChassis43s

thingiverse

Slotcar chassis designed specifically for GoPro Hero Session action cameras, utilizing ball bearings and 2mm axles. A guide is required for assembly. The recommended motor is the Carrera go motor or any other FF030 motor. Additionally, a 28-tooth spur gear with an m0.5 thread and an 8-tooth pinion with an m0.5 thread are necessary. One pinion should have a 1.5mm shaft for the motor, while the other should have a 2mm shaft for the intermediate axle. For this design, ball bearings with dimensions of 5x2x2.5mm are used on all axles, including the 2mm axle and 5mm outside diameter. The maximum diameter for front wheels is 11mm; however, larger wheels may cause the camera holder to drag. Rear wheels should have a minimum diameter of 16mm. For tracks with elevation changes, refer to CamChassis43s_V2. A separate design, CamChassis43s_808, accommodates an 808#16 camera.