Caliper Mount 10mm magnets

thingiverse

Slight remix to add an extra 4 holes on the back, to give a total of 5 10mm disc magnets. My cheap eBay magnets are 10x1.76mm so I used 2 in each hole, and a dab of superglue for good measure. The original design is sized well and fits all the cheap calipers I had on hand. I printed in eSun PLA+ with a 0.8mm nozzle and a 0.3mm layer height - I am trying to use up some filament and playing with larger nozzles. This would work just as well and look better with a 0.4 nozzle and 0.2 layer height. I ran 15% infill but it is not exactly load bearing, so you'll get by with less. I printed it flat back down to the bed, I may try another one up on its edge. I coloured the caliper logo with a fine tip permanent marker, flooding it with paint would work better.