Calibration Cube Set

thingiverse

I know there are many calibrating cubes out there, but none of them met my requirements. Again and again, the printed parts didn't fit together properly. Of course, you can edit the problem in the slicer, but I'm not solving the root cause by doing so. That's why I designed this stackable set. It can be used to test for over or under extrusion. The bolt must fit into the hole of the cube with minimal friction without falling out at the bottom. If the bolt doesn't fit in -> overextrusion, if it falls through -> underextrusion. In both cases, you should then calibrate your extruder. There's also the possibility to adjust acceleration values, line width and flow. However, you'll need to print multiple cubes with different values.