Cage Corner Bracket Reinforced

thingiverse

The brackets from Atomotec were a bit too large for my cage. When I scaled them down by 85% so they fit, one of them broke because it wasn't strong enough. I loaded the bracket into Tinkercad and added 2 mm to the top and sides before replacing the broken one. About a week later, another corner bracket broke and was replaced. The other four seem okay so far. To create a bracket for the straight sections, I clipped off the end of the corner bracket in Tinkercad and made it longer. It ended up being too short to hold well, so I'm printing more at 150% length. The straight bracket is uploaded with both original and reinforced dimensions. Update: The straight brackets tend to split when printed flat on their backs. Printing them vertically as they are in the STL may help prevent this issue.