Caddx Turtle V2 BetaFPV(26.5mm holes) & RunCam TX200 Canopy

thingiverse

A protective enclosure to house the Caddx Turtle V2 camera with a RunCam TX200 vtx or similar size that mounts on the rear of a micro camera is needed. The canopy in the photos is printed from NinjaTek Armadillo 75D TPU, but it can be printed from 95-98A TPU since it was originally prototyped using 95A. I printed it with an infill of about 75%. As long as your shell is at least 1mm thick, there will be no infill in the actual canopy walls. INSTALLATION INSTRUCTIONS Cut the material between the flap and the antenna mount with some side cutters. Do the same to the ball on the end of the antenna holder. Next, insert the VTX into the top by passing the antenna through the flap at the rear and screw it into the canopy. Then move the antenna through the gap you cut to the antenna holder. Once the VTX is mounted, fold the flap on the bottom at the front bottom and carefully slide in the camera with the harness at the top (normal cam orientation). Screw it into place with the usual cam screws. Now tuck all cables away as best possible and mount the PCB with the SD card oriented to the flap on the side.