Cable to back

thingiverse

switches, controllers, routers, poe switches. Many come with the ethernet connections in the front. Making for a gobbly goop mess of cables. Print this add between your devices. Leave the mess in the back. Can be printed in vase-mode/spiralize mode and prints in about 1.5 hours. settings I used for quick prints not using spiralize mode: .8mm line width with .4mm nozzle .3mm layer height 103% flow 75mm/s print speed 4 bottom layers 8 top layers (to compensate for sag) 0% infill no supports designed to be glued together for other port devices can also be scaled in the z direction depending on your needs ADDED: Closer to double side tape to lower device. Prevents cables moving while positioning and devices moving once set down. I double side tape the main print to the bottom of the device, put the cables in add 2 closers to each end and where there are cables, put double side tape on the closers then place where I want it on the lower device. This allows me to add and remove cables by just lifting the device im working with. I didn't get a before picture but trust me it was ugly! would love to see some before and after images of prints.