Cable Tie Holder for Rapide Lite's

thingiverse

Cable Tie Holder for a Countersunk Hex Nut (4mm). Holds Cable Ties for Easy Cable Management on Rapide Lite-Models. Print with No Supports or Brims Required. Print 8 Copies at Once, One for Every Hex Nut on the Chassis. Use This Design If You're Worried About Plastic Interfering With Print Stability: Try Using One Holder for Every Other Two Hex Nuts. The Cable Tie Holders in These Photos Were Printed at: * 0.1mm Layer Height * 0.25mm First Layer Height Model Created Using Sketchup 2013 and Refined with netfabb Azurewebsites.net Before Printing on a Rapide Lite 200. This Design Requires a Relatively Short Print Time, With Seven Holders Printed in Just 40 Minutes - Including Warm-Up Time. Instructions for Installing the Cable Tie Holders: * Start by Unscrewing One Nut at a Time * Place Each Holder Directly in Front of Its Corresponding Hex Nut Before Inserting It